Preparation

• Ensure that the surface is cool before and during painting. Clean surface by removing all loose paint and rust, dirt, grease and salt. Remove grease. Rinse with clean water and allow time to dry.

Note: Special precautions should be taken to avoid inhalation of dust during surface preparation of pre-1960's paint surfaces as they may contain harmful lead.

Application

• Store aerosol at room temperature for two hours prior to use. Shake can vigorously, in a vertical motion, until the agitator ball is heard and then for a further 3 minutes.
• Apply light even coats, from a distance of approximately 15cm (6") and keep the aerosol moving. Do NOT concentrate spray in one spot.
• Apply 3-4 coats for maximum protection and allow 15 minutes between coats. Between coats invert can and spray for 2 seconds to avoid blockages.

Cleaning & Storage

Protect aerosol from direct sunlight and do NOT expose to temperatures exceeding 50ºC (120ºF). Do not pierce or burn, even after use.

Tools Required

Wire brush or coarse sandpaper, goggles and protective gloves.