Preparation

• Remove all loose rust, dirt, grease and salt with Hammerite Brush Cleaner & Thinners and rinse with clean water. Allow time to dry.
• Degrease surface if necessary. For maximum adhesion on clean steel abrade surface with coarse sandpaper.

Application

• Store aerosol at room temperature for two hours prior to use.
• Shake can vigorously, in a vertical motion, until the agitator ball is heard and then for a further 3 minutes.
• Apply light even coats, from a distance of approximately 15cm (6") and keep the aerosol moving. Do NOT concentrate spray in one spot.
• Apply 3-4 coats for maximum protection and allow 15 minutes between coats.
• Between coats invert can and spray for 2 seconds to avoid blockages.

Cleaning & Storage

Protect aerosol from direct sunlight and do NOT expose to temperatures exceeding 50ºC (120ºF). Do not pierce or burn, even after use.

Tools Required

Coarse sandpaper and Hammerite Brush Cleaner & Thinners.